georgia-market.com moderated newsgroup and market bazzar > Milledgeville
> Construction
> New millermatic 140 mig welder, mil 907311,
New millermatic 140 mig welder, mil 907311,
* Flux Cored (FCAW) (gas and self-shielded)
* Requires Single-Phase Power
* 90 A at 18 VDC, 20% Duty Cycle
* 6 ft (1.8m) power cord and plug
* 10 ft (3 m), M-10 Miller MIG Gun and Cable Assembly #195 605
* 10 ft (3 m) Work Cable with Clamp
* Smith® Argon and AR/CO2 Mix Regulator/Flow Gauge with hose
* Spool of Hobart® .024 in (0.6mm) Solid Wire
* Two Contact Tips for .024 in (0.6mm) Wire
* Two Contact Tips for .030 in (0.8mm) Wire
* Dual Groove quick-change Drive Roll for .024 in (0.6mm) or .030/.035 in (0.8mm) Wire
* Factory-installed Gas Solenoid Valve
* Set-up and Operational Video
* Information/Settings Chart
All-In-One Wire Welding Package
Welds 24 gauge - 3/16 in (0.8 - 4.8 mm) Mild Steel.
Patent-pending technology provides a smooth, spatter-free start. It's the best-starting machine in the small MIG machine catagory. No pop gun starts and no spatter to clean up.
Infinate Voltage Control with Manual On/Off Wire Feed Speed Tracking
Miller's Exclusive "Tip Saver" Short Circuit Protection
Short circuit protection shuts down output when tip is shorted to the work. Extends contact tip life and protects internal components from damage. Trigger Reset permits quick reset at torch rather than unit.
Durable Cast Aluminum Feedhead
Incorporates dual-groove quick-change drive roll and spring-loaded tension arm with calibrated tension knob, all designed to make setup easier and faster.
Standard Built-in Solid-State Contactor Circuit makes wire electrically "cold" until trigger is pulled. Makes unit safer, and is easier to position torch to work before starting weld.
Internal components are protected from damage by thermal overload protection which automatically shuts down the unit and activates the over temperature light if duty cycle is exceeded or air flow and cooling are restricted. Automatically resets when fault is corrected and the unit cools.
Self-resetting Motor Protection Circuit
Eliminates the need to find and replace fuses.
* Money Orders & Cashier Checks may be sent to:
* Orders generally take 5-6 Business Days to reach you.
If your package arrives damaged, please contact us to arrange the best way to handle your return.
Due to safety requirements involved with much of the equipment we carry, product returns of used equipment is handled on a case-by-case basis.
