georgia-market.com moderated newsgroup and market bazzar > Dalton
> Electronics
> Small table top milling machine
Small table top milling machine
USED SMALL TABLE TOP MILLING MACHINE
The table measures 5-1/4 inches by 19-3/4 inches.
The head can be raised and lowered 5 inches and can be angled front to back and left to right.
One picture shows the head angled to the left.
One picture shows the shaft that slides moving the head from front to back.
Also the main upright post can be unpinned and the head can be rotated left to right.
It plugs into a regular 120 volt wall outlet.
It measures 37-1/2 inches tall from table top to top of the motor when the head is lowered to its lowest height.
One of the pictures show a round silver colored disk. It has markings on it to show the number of degrees you are moving the head when angling it front to back..
There is a small amount of surface rust that can be removed with steel wool or fine emery paper. The rust is not pitted into the steel. Over all the machine looks to be in real good condition.
Measurements of the taper shaft attached to the drill chuck are as follows
The length from the end to the just before the chuck is 4-¼ inches.
The length from the end to the end of the taper is about 4 inches.
The end of the shaft measures .95 inches.
The largest diameter at the end of the taper is 1.233 inches.
There is a key way about 3-¾ inches long from the end extending toward the taper.
The key way is about .15 inches wide.
The table can also be rotated 40 degrees to the left and right.
I have added pictures to show adjustments that can be made with the table and head.
IF YOU HAVE ANY QUESTIONS DON'T HESITATE TO ASK
