georgia-market.com moderated newsgroup and market bazzar > Athens
> Industrial
> Light Industrial
> 7 cp planishing hammer die english wheel
7 cp planishing hammer die english wheel
Exclusively by Hoosier Pattern
This Means that if the Item is; Delayed, Lost, Damaged or Whatever We Are Not Responsible.
Who are We? Can you Trust Our Quality? Want Answers?
Go to which is the Worlds Largest Metal Shaping Community. This site is Full of Guys and Gals doing Everything you could imagine when it comes to Body Repair, Scratch Built Cars and Bikes, Airplane Repair, Artist, Fabricators, and Guys and Gals just tinkering around. Metal Meet has an International Meet once a Year in centrally located Oblong IL, and Many of it's Members host Smaller Regional Events to further Share the Metal Shaping knowledge. My user name on Metal Meet is Joe Andrews, the Company Hoosier Pattern either name can be searched on Metal Meets Site.
This Complete Set of CP Hammer dies are the Best on the Market!
Polished to a mirror smooth finish these dies require no preparation to start forming sheet metal.
Remember that your Panels will only be as good as the Tooling used to make them!
These dies are 13/16's (.810) shanks and meet original Tolerance Specification.
Made from S7 Tool Steel then Heat Treated to 62 Rockwell. These are the hardest sets made and will last forever.
This set is a "Complete Set" and consist of:
New on the Market the contacts on these dies ensure maximum coverage!
***A Bonus from Hoosier Pattern!
We're throwing in Your Choice thats Right, YOUR CHOICE! of an Upper Die with this set!
The Last Picture shows all three Upper Dies, the Winner gets Their Choice of Which one they want!
Sorry but only one Upper Die goes with this set, but you do get all 6 lowers!
Upper #1 is an Oversized Upper Die it also is polished to a smooth finish, and it's 2 1/2 Inches Round. This Upper fits CP Type 1 and Type 2 Air Hammers, The o-ring groove has beautifully radiused edges to extend your o-rings life, No Sharp Edges like the Originals had!
Upper #2 is a Standard .401 Diameter Shank. This Die features a 1" Diameter Head and is by far the most common Upper Die we Make. This Die fits over 30 different Air Hammers!
Upper #3 is also .401 Diameter Shank. This Die features a 1½" Diameter Head, this is a very desirable Tool because it's oversize! This Die also fits over 30 different Air Hammers!
Please Look very closely at the Pictures, as they say "A Picture says a thousand words".
All 6 Lower Dies are Included plus Your Choice of An Upper Die!
© Copyright 1999 - 2008, All Rights Reserved
If you have questions regarding anything to do with these Anvils please don’t hesitate to ask, e-mail ****@hoosierpattern.com
